You are here: home->amg->D01->D.8.1.9.4.A.1
8194
From the following sequences of steps, indicate the proper order you would use to make a single flare on a piece of tubing:
| 1. |
Place the tube in the proper size hole in the flaring block. |
| 2. |
Project the end of the tube slightly from the top of the flaring tool, about the thickness of a dime. |
| 3. |
Slip the fitting nut and sleeve on the tube. |
| 4. |
Strike the plunger several light blows with a lightweight hammer or mallet and turn the plunger one half turn after each blow. |
| 5. |
Tighten the clamp bar securely to prevent slippage. |
| 6. |
Center the plunger or flaring pin over the tube. |
| | A) 1, 3, 5, 2, 4, 6. |
| | B) 3, 1, 6, 2, 5, 4. |
| | C) 3, 1, 2, 6, 5, 4. |
|
|
|
